NEW SNUG FIT JIGS FEATURE TAPERED INTERNAL SIDES TO HOLD ONTO YOUR PANELS

Depths from 16mm to 32mm are available, this is usually your door thickness plus 2mm for your door buffer.

This will allow you to get the exact spacing required for flush to door end panels when fitting kitchens.

By using another jig on its end placed against your offset jig at top and bottom of the panel, you can then use an 18mm scribing block to get the perfect scribe to the wall.

There is a hole in the top of each block so it can be fixed to the top of a panel and hung on the side of a wall cabinet to get an exact overhang. For example, if you are running your cornice into your wall end panels, you may want a 31mm top panel overhang for a 30mm cornice to run into.

Please note that as kitchen panel sizes do differ, a panel advertised at 18mm may be 19mm and the jig may not fit on the panel.

This product is 3D printed, and as such, printing lines are visible on the finished product. These do not affect functionality.

Colour may vary due to supply issues.

PLEASE ALWAYS TEST JIG ON AN OFFCUT TO MAKE SURE IT DOES NOT DAMAGE THE PANEL FINISH, AND NEVER USE EXCESSIVE FORCE WHEN PUTTING THE JIG ONTO A PANEL