This Brivis 5-bank heat exchanger is a direct replacement part for Brivis Buffalo series gas heaters. Keeping your heater running smoothly means less downtime and more reliable warmth for your clients, especially through those chilly Australian winters.

When you're out on a service call and an old heat exchanger is shot, having the right part on hand or knowing where to get it fast makes all the difference.

Best For

• HVAC technicians performing Brivis heater maintenance and repairs.
• Experienced gas fitters replacing worn heat exchangers.
• Owners of Brivis Buffalo series ducted gas heaters requiring genuine spare parts.

Compatibility

This heat exchanger is specifically designed for Brivis Buffalo series gas heating units. It's identified by Brivis Part Number 80013214 (or B013214).

If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Brivis spare part, ensuring direct fitment and manufacturer performance.
• Five-bank design as per original Buffalo series specifications.
• Designed for durability within Brivis Buffalo gas heating systems.

What's in the Box

• 1 x Brivis Heat Exchanger 5 Bank Buffalo Series (BS80013214)

Using It on the Job

1. Always isolate power and shut off the main gas supply to the unit before commencing any work.
2. Depressurise the gas line and check for any residual gas before disconnecting components.
3. Carefully remove the old heat exchanger, noting the position of all gaskets and mounting hardware.
4. Inspect the combustion chamber for soot, corrosion, or foreign objects, cleaning thoroughly if necessary.
5. Install the new Brivis 5-bank heat exchanger, ensuring all seals are correctly seated and hardware is securely fastened.
6. Reconnect gas lines, check for leaks with an appropriate gas leak detector, and verify proper flue operation.
7. Restore power and gas, then perform a full operational check of the heating unit, including ignition and safety cut-outs.

Limitations & Safety Notes

• Installation and servicing of gas appliances must only be performed by a licenced gas fitter.
• Work on refrigerant circuits requires a current ARCtick licence, if applicable to the system.
• This part is exclusively for Brivis Buffalo series gas heaters with the specified part number.
• Always follow the manufacturer's installation instructions and relevant Australian standards.
• Ensure adequate ventilation during and after installation.

Tradie Pro Tip

When you're swapping out a heat exchanger, take the extra five minutes to give the surrounding areas a good clean. Dust and crud can restrict airflow or cause issues down the track, so it's worth getting it spotless while you have access.

Pair With

Pair with a reliable gas leak detector and appropriate Brivis control boards for a full service. Check out our range of test and measurement tools for your commissioning and troubleshooting needs.