Why this controller vs. the conventional setup

• Float-switch fault awareness — detects a jammed or failed float and flags it instead of silently cycling into a sewage backup.
• Dry-run protection — stops the pump before an empty-sump run damages the impeller or seals.
• Real-time monitoring — continuous pump-operation tracking so faults surface in real time.
• IP67 enclosure — rated for sewage-adjacent wet environment.
• Operating-hour and cycle tracking — for maintenance planning and warranty.
• Optional remote / wireless monitoring — available as an add-on for lift stations and remote-site installs.

Specifications

• Form factor: pre-wired IP67 sewage pump controller
• Enclosure rating: IP67
• Application: dedicated sewage / wastewater installations — submersible or dry-pit, lift stations, septic and commercial sewage
• Float-switch logic: active fault-detection topology (vs passive continuity)
• Dry-run protection: impeller / seal protection on empty-sump conditions
• Tracking: operating hours and cycle count
• Origin: Designed and assembled in Pittsboro, NC
• Datasheet: full specifications (input voltage, pump compatibility, float-switch wiring, remote-monitoring protocol, dimensions) available on request — contact us.

FAQ

Compliance & origin

• Origin: Assembled in Pittsboro, North Carolina, USA. Components are sourced from global suppliers; final assembly, firmware, and QC happen in the NC workshop.
• Enclosure: IP67 rated for sewage-adjacent wet environment.
• Support: ticket-based support direct from the people who built the hardware — open a ticket.
• Warranty & certifications: available on request — open a ticket for the current scope.